omniscan14-相控阵TCG校准方法.pdfVIP

OmniScan MX2 Training Program OmniScan MX2 培训 TCG Calibration Wizard TCG校准向导 OmniScan MX2 Training – TCG Calibration Wizard Overview OmniScan MX2培训——TCG校准向导概述  The MX2 TCG calibration wizard is designed to equalize the amplitude of all A-scans or focal laws in the group over the sound path range with a series of calibration targets.  MX2 TCG校准向导用于补偿组中带一系列校准目标的声程范围内所有A-扫描或聚焦法则  This is the same function as a conventional single channel instrument with the exception that it is performed on many focal laws or A-scans simultaneously.  这是和常规但通道设备一样的功能，除了它是在许多聚焦法则或A-扫描上同时进行的。  In conventional UT, TCG or DAC calibration is achieved by manually adjusting the gain until the reflected signal is at a predetermined amplitude at each calibration target over the sound path, typically 80%.  在常规UT、TCG或DAC中，通过手动调节增益，直到反射信号在声程内每个校准目标处达到预定 的振幅，通常为80%。  The TCG calibration wizard uses the same interface as the sensitivity calibration with the exception that it does not allow a negative gain correction and it can be used on successive calibration targets by moving gate A to the next target.  TCG校准向导使用与灵敏度校准一样的界面，除了不允许一个负的校准，且通过移动门A道下一 个目标，它可用于连续的校准目标 2 OmniScan MX2 Training – TCG Calibration Wizard Overview cont. OmniScan MX2培训——TCG校准向导概述  Like in conventional UT, the TCG calibration allows flaws of the same size to appear at the same amplitude and color for different angles and sound paths.  与常规UT一样，对于不同角度和声程，TCG校准允许相同尺寸缺陷出现在同一振幅和颜色。  Without use of the TCG, the amplitude based acceptance criteria such as ASME and similar code cannot be achieved on all focal