水浴加热温度控制器设计.pdfVIP

水浴加热温度控制器设计 水浴加热温度控制器设计 [摘要] 现如今温度控制可以说是无所不在。不论是在工业生产还是在日常生活当中， 水温控制都起着重要的作用。本文介绍了基于 STC12C5A60S2 单片机水温测量及控制系统 的设计。系统硬件部分由单片机电路、温度采集电路、键盘电路、LCD12864 显示电路、 继电器控制电路组成。软件从设计思路、软件系统框图出发，逐一分析各模块程序算法 的实现，通过C 语言编程写出满足任务需求的程序。本系统采用数字温度传感器 DS18B20 作为温度传感器，具有体积小，抗干扰能力强的优点。单片机通过温度传感器 DS18B20 对水的温度进行有效监测与报警，当水温高于设定值时报警，当水温低于设定值时自动 加热并保持恒温，以此进行水温的控制。基于单片机水温控制系统采用多电源供电，降 低了各模块间的干扰，保证了电源能为各模块提供足够的工作电流，提高系统的稳定性 及可靠性。 [关键字] 水温控制 单片机 传感器 监测 报警 I 水浴加热温度控制器设计 The design of base on Microcontroller on heating in water temperature controller [Abstract] Temperature control can now be said to be everywhere. Whether in industrial production and in daily life, temperature control plays an important role. This paper introduces the single-chip based STC12C5A60S2 temperature measurement and control system design. System hardware circuit by the microcontroller, temperature acquisition circuit, keyboard circuit, LCD12864 display circuit, relay control circuit. Software from the design ideas, software system block diagram view, each module analyzes the achievement of the program algorithm, written by C language programming to meet the mission requirements of the program. The system uses digital temperature sensor DS18B20 as a temperature sensor, with a small, anti-interference ability of the advantages. Single-chip temperature sensor DS18B20 water temperature for effective monitoring and alarm, when the water temperature is higher than the set value of the alarm, when the water temperature drops below the set value is automatically heated and maintained at a constant temperature, in order to carry out temperature control. Microcontroller-based temperature control system uses