各种触发器的VHDL程序.pdfVIP

题目：写出带异步复位边沿（下降沿） JK 触发器的 VHDL 程序： LIBRARY IEEE; USE ENTITY jk1 is PORT (clk,R,S : IN STD_LOGIC; j,k: IN STD_LOGIC; q,qn : OUT STD_LOGIC); END jk1; ARCHITECTURE one OF jk1 IS SIGNAL q_s : STD_LOGIC; BEGIN PROCESS (R,S,clk,j,k) BEGIN IF (R=1 AND S=0) THEN q_s=0; ELSIF(R=0 AND S=1) THEN q_s=1; ELSIF clkEVENT AND clk=0 THEN IF (J=0 AND k=0) THEN q_s= q_s; ELSIF (J=0 AND k=1)THEN q_s=0; ELSIF (J=1 AND k=0)THEN q_s=1; ELSIF (J=1 AND k=1) THEN q_s=NOT q_s; END IF; END IF; END PROCESS; q=q_s; qn=not q_s; END one; 基本 RS 触发器 entity rsff is port(r,s:in std_logic; q,qb:out std_logic); end rsff; architecture rtl of rsff is signal q_temp,qb_temp:std_logic; begin process(r,s) begin if(s=1 and r=0)then q_temp=1; qb_temp=0; elsif(s=0 and r=1)then q_temp=0; qb_temp=1; else q_temp=q_temp; qb_temp=qb_temp; end if; end process; q=q_temp; qb=qb_temp; end rtl; . 同步 RS 触发器 library ieee; use synrsff is port(clk,r,s:in std_logic; q,qb:out std_logic); end synrsff; architecture rtl of synrsff is signal q_temp,qb_temp:std_logic; begin process(clk,r,s) begin if(clk=1)then if(s=1 and r=0)then q_temp=1; qb_temp=0; elsif(s=0 and r=1)then q_temp=0; qb_temp=1; else q_temp=q_temp; qb_temp=qb_temp; end if; else q_temp=q_temp; qb_temp=qb_temp; end if; end process; q=q_temp; qb=qb_temp; end rtl; . 同步 D 触发器 l