外转子无刷直流永磁电动机结构.doc

外转子无刷直流永磁电动机结构 在无刷永磁电动机原理一节中曾介绍一个具有六凸极的内定子与外转子的模型，这里 介绍的外转子直流无刷永磁电动机，采用有18个凸极的内定子，由冲制的硅钢片叠成，见 下图。 为减轻重量，定子中心部分是空的，由内定子机架与转轴机座固定，见下图。 plates for tank lap, not fixed. Protect wires should be left in the ground and slot the compensation allowance. Metal cable trays and support and the introduction of metal cable ducts must be drawn or ground (PE) or zero (PEN) reliable and must comply with the following requirements: 1.1 metal cable trays and support full length not less than 2 in the grounding (PE) or zero (PEN) trunk connections; 1.2 non-galvanized cable bridge between both ends of the connection plates bridged copper ground wire, grounding allowed minimum cross-sectional area of not less than 4mm2; 1.3 galvanized cable bridge across both ends of the connection between the grounding wire, connect both ends of the Board not less than 2 locking nut and lock washer fixing bolts of the connection. Cable trays installed in accordance with the following provisions: 2.1 straight steel cable tray lengths not exceeding 30m, aluminum or fiberglass Cable Tray lengths over 15m with the slip joint; cable bridge spans the building set a compensation slot; 2.2 the bending radius of the cable tray bend, not less than minimum tray cable allows the turning radius, minimum bending radius of the cable shown in the table below; Table cable minimum allows bent RADIUS serial number cable type minimum allows bent radius 1 no lead Bao Gangkai nursing sets of rubber insulation power cable 10D 2 has steel armored nursing sets of rubber insulation power cable 20D 3 PVC insulation power cable 10D 4 make joint PVC insulation power cable 15D more than 5 more core control cable 10D Note: d for cable od 2.3 Dang design no requirements 在定子凸极上绕有励磁线圈，用来产生旋转磁场。 在定子机架上还安装有4个反射式光电开关元件(见下图)，与转子外壳内安装的编 码盘一同组成转子位置检测装置。 plates for tank lap, not fixed. Protect wires should be left in the ground and slot the compensation allowance. Metal cable trays and support and the introduction of metal cable ducts mus