转动器底盘冲压工艺及模具设计说明书.docVIP

西华大学毕业设计说明书 西华大学毕业设计说明书 摘 要 此次毕业设计的题目是转动器底盘冲压工艺及模具设计。在设计时，首先对工件进行工艺分析，根据工件的形状特征、尺寸、材料等判断其所需加工的工序为：落料、起伏成型、冲多小孔等工序。对于所列各道加工工序，在对其冲压变形性质、质量要求、经济效益及操作的方便性等综合因素的比较后，确定其冲压方案为先落料拉深，然后起伏成型，最后冲孔。即使用一套复合模和两套单工序模具来完成上述工序。在模具设计过程中，对每道工序进行冲压工艺分析，然后对该副模具进行刃口尺寸计算，设计定位零件、卸料零件及结构零件，选择各个标准零件的类型和结构。最后用CAD软件绘制出模具装配图和部分零件图，并完成设计说明书的编写。 【关键词】冲压模具设计、落料拉深、起伏、冲孔 Abstract The title of the graduation project is the computer chassis connecting sheet stamping process and mold designAt the time of design, the workpiece is first subjected to a process analysis, and the process steps required for the workpiece to be determined based on the shape characteristics, dimensions, and materials of the workpiece are: blanking, ups and downs, multiple holes, bending, and the like.For each listed process, after comparing the stamping deformation properties, quality requirements, economic benefits, and ease of operation, determine the stamping scheme for the first blanking, then punching and trimming, and finally folding bend.That is, the above steps are completed using two sets of composite molds and a single set of process molds.In the mold design process, the stamping process analysis is performed for each process, and then the edge of the auxiliary mold is calculated, and positioning components, unloading components and structural components are designed, and the type and structure of each standard component are selected.Finally, the mold assembly drawing and some parts drawing are drawn with the CAD software, and the preparation of the design specification is completed. 【Key words】Stamping die design； blanking,；rising formation； Punching and cutting；bending 目 录 摘要 Ⅰ 15781_WPSOffice_Level1 1． 前言 1 2286_WPSOffice_Level1 2． 工件工艺性分析 2 29239_WPSOffice_Level2 2.1工件的工艺性分析 2 12506_WPSOffice_Level2 2.2制定冲压工艺方案 3 12715_WPSOffice_Level2 2.3 每副模具所生产的工件简图 5 13438_WPSOffice_Level2 2.4排样设计 5 10717_WPSOffice_Level2 2.5冲压力的计算及压力机的选择 7 26405_WPSOffice_Level2 2.6 起伏力的计算及压力机的选择 9 21071_WPSOffice_Level2 2.