计算机网络安全与管理：第四讲.pptVIP

* Now discuss each of the four stages used in AES. The Substitute bytes stage uses an S-box to perform a byte-by-byte substitution of the block. There is a single 8-bit wide S-box used on every byte. This S-box is a permutation of all 256 8-bit values, constructed using a transformation which treats the values as polynomials in GF(28) – however it is fixed, so really only need to know the table when implementing. Decryption requires the inverse of the table. These tables are given in Stallings Table 4.5. The table was designed to be resistant to known cryptanalytic attacks. Specifically, the Rijndael developers sought a design that has a low correlation between input bits and output bits, with the property that the output cannot be described as a simple mathematical function of the input, with no fixed points and no “opposite fixed points”. * As this diagram from Stallings Fig 5.4a shows, the Byte Substitution operates on each byte of state independently, with the input byte used to index a row/col in the table to retrieve the substituted value. * The ShiftRows stage provides a simple “permutation” of the data, whereas the other steps involve substitutions. Further, since the state is treated as a block of columns, it is this step which provides for diffusion of values between columns. It performs a circular rotate on each row of 0, 1, 2 3 places for respective rows. When decrypting it performs the circular shifts in the opposite direction for each row. This row shift moves an individual byte from one column to another, which is a linear distance of a multiple of 4 bytes, and ensures that the 4 bytes of one column are spread out to four different columns. * Stalling Figure 5.5a illustrates the Shift Rows permutation. * The MixColumns stage is a substitution that makes use of arithmetic over GF(2^8). Each byte of a column is mapped into a new value that is a function of all four bytes in that column. It is designed as a matrix multiplication where each byte is tre