workbench电机电磁场有限元分析.pptxVIP

workbench电机电磁场有限元分析第1页/共44页 10/1/20042Motor Analysis in the Workbench EnvironmentYou should see an end view of the motor geometry. Using the left mouse button (LMB) click on the blue dot adjacent to the triad in the lower right corner of the plot. This should result in the isometric view shown at right.The image can be dynamically rotated as follows:Position the mouse cursor on the displayHold down the middle mouse button (MMB)Move the mouse cursor第2页/共44页 10/1/20043Motor Analysis in the Workbench EnvironmentBring up the enclosure tool as shown at right. This will be used to automatically create a mesh of the magnetic domain between and surrounding the imported geometry Note the details that appear in the lower left pane after this selection is made. We will edit these default values.12第3页/共44页 10/1/20044Motor Analysis in the Workbench EnvironmentClick on the individual entries in the right hand column of the details pane and edit them as shown below.Enclosure name changed to “Air”Shape: CylinderAlignment: AutomaticCushion: 8 mmTarget: All BodiesMerge Parts?: Yes第4页/共44页 10/1/20045Motor Analysis in the Workbench EnvironmentAfter editing the details, right click on “Air” in the tree. In the drop down list that appears, left click on “Generate”. This will create a cylindrical volume of magnetic domain in which to immerse the imported parts. 第5页/共44页 10/1/20046Motor Analysis in the Workbench EnvironmentIn the tree, open the item “1 Part, 5 Bodies” by clicking on the “+” symbol to the left of it. Do the same with the item labeled “part” that appears below it. Note that the single part in the model consists of 5 individual bodies (stator, rotor, magnet1, magnet2, and “solid”). Right click on “solid” and in the drop down menu, request that it be hidden in the display. Note that the display of any individual bodies may be either suppressed or restored in this manner.12第6页/共44页 10/1/20047Motor Analysis in the Workbench EnvironmentUse the Winding Tool Editor to bring up the