电气SHELL壳牌规范33683033.docxVIP

TECHNICAL SPECIFICATION ELECTRICAL PROCESS HEATERS DEP 3-Gen. November 2022 DESIGN AND ENGINEERING PRACTICE This document is restricted. Neither the whole nor any part of this document may be disclosed to any third party without the prior written consent of Shell Global Solutions International B.V., The Netherlands. The copyright of this document is vested in this company. All rights reserved. Neither the whole nor any part of this document may be reproduced, stored in any retrieval system or transmitted in any form or by any means (electronic, mechanical, reprographic, recording or otherwise) without the prior written consent of the copyright owner. DEP 3-Gen. November 2022 Page 2 PREFACE DEPs (Design and Engineering Practice) publications reflect the views, at the time of publication, of: Shell Global Solutions International B.V. (Shell GSI) and/or Shell International Exploration and Production B.V. (SIEP) and/or other Shell Service Companies. They are based on the experience acquired during their involvement with the design, construction, operation and maintenance of processing units and facilities, and they are supplemented with the experience of Shell Operating Units. Where appropriate they are based on, or reference is made to, international, regional, national and industry standards. The objective is to set the recommended standard for good design and engineering practice applied by Shell companies operating an oil refinery, gas handling installation, chemical plant, oil and gas production facility, or any other such facility, and thereby to achieve maximum technical and economic benefit from standardization. The information set forth in these publications is provided to Shell companies for their consideration and decision to implement. This is of particular importance where DEPs may not cover every requirement or diversity of condition at each locality. The system of DEPs is expected to be sufficiently flexible to allow individual Operating Units to adap