钢化玻璃隔断的施工工艺标准.docxVIP

钢化玻璃隔断的施工工艺标准 Chapter 5: n Plan and Technical Measures for Sub-Projects n 5: n Standards for Tempered Glass ns 1.This n standard applies to the n of glass ns and walls for the indoor building of this project. 2.Material Requirements: 1) All glass varieties。ns。performance。patterns。and colors used in the glass n project must meet the design requirements. 2) The aluminum alloy frames。stainless steel plates。1.2mm thick stainless steel plates。angle steel。channel steel。eight thin-walled channel steel。support hangers。and other metal materials and supporting materials used in the glass n project must meet the design requirements and relevant standards. 3) Other materials used。such as n bolts。glass support pads。rubber fittings。metal fittings。structural sealants。etc。must meet the design requirements and relevant standards. 3.Main Equipment: Main equipment includes welding machines。impact drills。drills。cutting machines。wire saws。glass n cups。small steel saws。rulers。spirit levels。tape measures。hammers。wrenches。screwdrivers。calipers。caulking guns。glass n machines。etc. 4.Operating ns: 1) The main structure project has been completed and accepted. 2) The n benchmark lines and points have been tested. 3) The embedded parts。connecting parts。or metal grooves for embedded glass have been completed and checked to meet the requirements. 4) The glass embedded grooves are cleaned and the drainage is unobstructed. 5) The required scaffolding or corresponding n facilities have been met. 6) The required materials and assembly equipment are available. 7) Corresponding n measures have been formulated and approved by nals before n. 8) The temperature during n is not lower than 5℃. 5.Operating Process: 1) Process Flow: Marking ning lines → Cutting and assembling frame materials → Fixing frames and installing steel frames for fixing glass → Installing glass → Sealing and caulking → Decorating frames → Cleaning. 2) Operating Process: A。Marking ning Lines: First。mark the ground n line。then use the