连续退火炉内取向硅钢来料板形对热瓢曲影响的研究.pdfVIP

连续退火炉内取向硅钢来料板形对热瓢曲影响的研究 孙 林1 戴江波2 姜 鹰2 （1.武钢设备维修总厂，武汉 430083 ；2.武钢工程技术集团设计研究院，武汉 430080 ） 摘 要 在工艺参数（温度、速度、张力等）设定情况下，连续退火炉内取向硅钢来料板形成为热瓢曲产生的一个 重要影响因素。针对来料板形分类，相应地简化为 5 种张应力横向分布仿真计算工况（双边浪、中浪、四分之一浪、 边中复合浪和单边浪）。采用 MARC 程序建立有限元法仿真计算模型，计算 5 种仿真工况下板带瓢曲变形的屈曲 临界应力和模态。计算结果表明：双边浪、边中复合浪板形极其容易发生热瓢曲屈曲问题，四分之一浪较容易发生， 中浪、单边浪板形很难发生；传动辊线速度一致性越好越不容易发生热瓢曲。 关键词 连续退火 取向硅钢 板形 热瓢曲 有限元法 Study on Effect of Strip Flatness on Heat Buckling for Cgo in Continuous Annealing Furnace Sun Lin1 Dai Jiangbo2 Jiang Ying2 (1. Equipment Repair Plant of WISCO, Wuhan, 430083; 2. Design Research Institute of WISCO, Wuhan, 430080) Abstract When the process parameters (temperature, speed, tension, etc) being remained certain, the strip flatness of cold grain-oriented silicon steel (CGO) become a leading factor of influencing hot buckling in continuous annealing furnace. The strip flatness is simplified as five kinds of simulation conditions on the transverse distribution of tensile stress correspondingly, namely, the long edges, the long center, the quarter buckles, the composite of the long edges and long center, the side buckles. By finite element method of MARC, the simulation calculation model is developed to study critical buckling stress and modal response on five kinds of conditions. The results show that the heat buckling is the easiest to happen when the strip with the long edges or the composite of the long edges and long center, and the most difficult with the long center or the side buckles, and the quarter buckles rank the middle. The synchronism of linear velocity on the drive roller is the better, the heat buckling is the less likely to happen. Key words continuous annealing, CGO, shape, heat buckling,