张力对电子铝箔性能影响的研究.pdfVIP

张力对电子铝箔性能影响的研究 张力对电子铝箔性能影响的研究 周亚军 程峰 何小龙 （中南大学机电工程学院 湖南长沙 410083 ） 摘 要：在Φ630mm×800mm/Φ260mm×900mm 四辊轧机上进行了不同张力轧制电子铝箔的试验，用Wyko NT9100 表面轮廓仪测试了电子铝箔表面粗糙度，按照SJ/T 10557.3—94 标准分析了铝箔表面位错密度，在 PROTO iXRD 残余应力测试仪分析了铝箔表面的残余应力，用ZEISS 扫描电镜测试了电极箔腐蚀孔的形貌。 结果表明：在试验条件下低张力轧制电子铝箔，轧制压力增加，表面粗糙度增大，但表面残余应力变小， 铝箔表面更加平整，表面位错密度增加，电极箔的腐蚀孔密度更加大而均匀,有利于提高电极箔的比电容。 关键词：电子铝箔、轧制张力、残余应力、位错密度、电极箔 Effect of Rolling Tension on the Performance of electronic aluminum foil Zhou Ya-jun Cheng Feng He Xiao-long (College of Mechanical and Electrical Engineering, Central South University, Changsha 410083，China) Abstract: The electron aluminum foil was rolled on four-high mills (Φ630mm×800mm /Φ260mm×900mm) with different tension. The surface roughness of the foil was measured with Wyko NT9100 surface profiler，the dislocation density was tested according to the SJ/T 10557.3—94 ，the surface residual stress was analyzed by PROTO iXRD residual stress tester, and the electrode foil surface was tested by ZEISS Scanning Electron Microscope. The results show that roll the electron aluminum foil with low tension under the experimental conditions, both rolling pressure and surface roughness increase, but surface residual stress reduces, the foil surface becomes more smooth, the surface dislocation density increases, and not only the density of the electrode foil corrosion hole is bigger but also its distribution is more uniform, which are beneficial to improve the specific capacitance of the electrode foil. Key words: electronic aluminum foil; rolling tension; residual stress ;dislocation density ；electrode foil 铝箔轧制是一门特殊的压延技术，由于产品的厚度小，在板带材轧制中起决定作用的控 制因素，如辊缝和轧制压力，在铝箔轧制中并不重要；而那些在板带材轧制中起次要作用的 因素，如张力和轧制速度，在铝箔轧制中有着