ERP项目检查更改显存等配置参数.docVIP

检查更改配置参数 一种方法可以直接更改系统中 I:\usr\sap\R3P\SYS\profile\R3P_DVEBMGS00_sapprdapp文件，加入你要更改的参数。 可以在SAP系统中使用RZ10来更改，方法和路线如下：1、系统中输入RZ10，如下图所示 2、在参数文件中选择子系统参数文件、其他2个文件不要动 3、选中文件后单击修改即可进行配置参数 4、配置参数如下，如遇需要但没有的参数，可以添加参数 5、更改后参数配置如下，更改依据示SAP GOLIVE CHECK给出的一些参数。 SAP System Configuration for R3P The R/3 Configuration Checks cover the correct parameter settings of each R/3 instance. SAP parameters are important for the stability and performance of an R/3 instance. Note: After any SAP parameter change in Windows NT, restart the system immediately to avoid problems. Software Configuration The table below shows the Support Packages applied: Release Patch Number Status of Patch Patch Type 53 I SAPKITAR53 AOI 470 15 I SAPKH47015 COP 06 I SAPKGPRA06 AOP 470 10 I SAPKE47010 COP 620 30 I SAPKB62030 COP 620 30 I SAPKA62030 COP PlugIn PlugIn Patch Level PI 2002_1_470 0003 PI_BASIS 2002_1_620 0006 ST-A/PI 01B_R3_470 0000 The current SAP R/3 Plug-In is out of full maintenance, which means that there are no Support Packages and Conflict Resolution Transports (CRT) available to maintain your software. You have to maintain the Plug-In with SAP Notes that are provided instead. Recommendation: Upgrade your Plug-In to the latest release available. You can find detailed information on the recommended upgrade path on the SAP Service Marketplace at the Internet address /R3-Plug-In - Upgrade - R/3 Plug-In Upgrade Matrix SAP Kernel Release Your SAP kernel release (release 620, patch level 1081) is not up-to-date. Recommendation: Ensure that you are using the latest SAP kernel. See SAP Notes 19466 and 138704. (These notes refer to further SAP Notes, depending on your system characteristics.) In case of SAP kernel release 610 or higher, please refer to Note 502999 as well. Memory Configuration for Instance sapprdapp_R3P_00 Recommendation: Adapt the R/3 instance parameters to the required values in profile I:\usr\sap\R3P\SYS\profile\R3P_DVEBMGS00_sapprdapp.Procedure:1. Use transact