2000m3运沙船结构及强度计算分析【毕业论文】.docVIP

本科毕业论文 （20 届） 2000m3运沙船结构及强度计算分析 专业：船舶与海洋工程 目录 摘要 1 前言 3 一、船体说明 5 1.1船舶航区用途: 5 1.2.船体结构情况 7 1.3.舾装设备 7 1.4舱室舾装部分 8 二、结构规范计算 11 2.1 船体外板 11 2.2 甲板 14 2.3 船底骨架 15 2.4 舷侧骨架 19 2.5 甲板骨架 21 2.6 舱口纵桁、横梁、支柱等 25 2.7 货舱平面横舱壁 27 2.8 甲板室 31 2.9 尾楼 33 2.10 首楼 34 2.11 首尾柱 35 2.12 舷墙及栏杆 36 2.13 货舱口及货舱内底板 37 2.14主要构件汇总 38 三、总纵强度计算 40 3.1船体梁弯曲强度 40 四、附相关结构图 45 4.1中横剖面图： 45 4.2基本结构图： 45 总结 46 [参考文献] 47 致谢 48 2000m3 sand carrier structure and strength computational analysis [Abstract] The ship is fully welded steel ships, set single continuous deck，tail has 3 deck rooms, the first increase in a 0.30m high deck, using double-machine, twin screw, streamlined double-supported balanced rudder. This design is mainly to the 2000m3 sand carrier structure and strength calculation analysis for the design, reference to the design plan requirements of the Vessel, and the ships main dimensions, general arrangement and sheer, accordance with the Steel Ships Classification and Construction canon(2006) calculated on the hull structure. This design is divided into two parts, Part 1: according to the Steel Ships Classification and Construction canon(2006) and relevant regulations, calculate the size of the various components and plate, according to the calculation result of selecting the required plate and section bar, finally, list summarizes the size of main structure. Part 2: according to the first part the calculations made to calculate of the size of the bottom, deck and various parts of the superstructure components, according to designing the requirement for the task, map out the ships basic structure and transverse section, reflect the size of the design of the ships bottom and main deck, side, the cabin area and superstructure components and the main components. Part 3, according to the size of component calculated and the transverse section had draw to check the ship strength, in order to achieve the required strength. The vessel length 83.52m, design draft 3.3m, the design displacement