《冲压工艺与模具设计》课件设计与制作.doc

毕 业 设 计 《冲压工艺与模具设计》课件设计与制作 ——拉深工艺与拉深模具设计、其他成形工艺及模具设计 Design and development of courseware for “stamping process and mold design”: deep drawing process and die design, other forming technology and mold design course 专业班级： 学生姓名： 指导教师： 学 院： 年 月摘 要 这篇文章围绕“冲压工艺和模具设计——拉深工艺与拉伸模具设计，其他成形工艺与其他成形模具设计”课件作品，阐述了课件开发的理论基础、教学设计、软件设计和制作流程。 论文开头阐述了《冲压工艺与模具设计》课件制作国内外研究的现状、趋势和存在不足，说明了这一课件作品制作的必要性。然后阐释了课件制作时遵循的理论基础，包括学习理论、教学理论及传播理论等。接着又说明了课件制作前进行教学设计和软件设计的流程，包括学习者特征分析、需求分析、环境分析、片头设计、主界面设计，子界面设计等。再后，讲述了课件制作工具的选择和具体制作过程，包括工具的选择依据，使用的具体方法和使用的基本过程。最后，总结制作过程中遇到的困难和解决办法及课件存在不足和改进方向。 关键词：拉深工艺；成形工艺；模具设计；课件 ABSTRACT This article works on the theoretical basis for courseware development, instructional design, software design and production process, which is based on multimedia courseware for “pressing technology and die design course”-deep drawing process and die design, other forming technology and die design course”. At the beginning, it described the status, trends and shortcomings of multimedia courseware for “pressing technology and die design course the pressing technology and die design at home and abroad, telling the necessity of production of this courseware work. Then it explains the theoretical basis for this courseware production, including learning theory, instructional theory and communication theory. And then it tells the process of instructional design and software design of courseware production, including learner characteristics, needs analysis, environmental analysis, trailer design, interface design, sub-interface design. After that, it is about the selection of courseware authoring tool and the production process, including the basis of choice of varied tools, the use of specific mode and the basic process. Finally, it is to sum up the difficulties encountered in the producing process, the resolution, the deficiencies and the direction of improvement of the courseware. Key Words：Deep drawing process; Forming technology; Mold design; Courseware 目 录 1 引言 1 2 理论