盘式制动器拆解动画.pdf

Disassembly of the BD-13 Disc Brake System Highlight Parts Show Step Involved 1. Remove Lug nuts 19mm Lug Nuts -- 6-point socket recommended 2. Remove nuts from knuckle bolts 13mm nuts 3. Slide Dust cover off of Knuckle bolts Wear a mask to avoid inhaling loose brake dust 4. Remove Knuckle Use a hammer to loosen if parts are rusted together 5. Remove Caliper assembly Do not allow caliper assembly to hang from brake hose 6. Slide apart Rotor and Hub Again, a hammer might be needed, use a thick rag or towel to prevent denting either part Reset Animation NOTE: Assembly is the reverse of Dissasembly Warning: If brake system has been in use, there will likely be some residual brake fluid in the hoses and in the pistons which will leak out with handling. Brake fluid is a category 4 corro- sive and will severely damage paint. Brake fluid is also a eye/skin irritant and this procedure should always be done with AEC approved gloves. If fluid is ingested, get to an emegency room immediately.