IPS-M-EL-144 material and equipment standard for medium and high voltage switchgear and controlgear英文资料.pdfVIP

IPS-M-EL-144(1) FOREWORD This Standard is intended to be used within and for Iranian Ministry of Petroleum (N.I.O.C, N.I.G.C, N.P.C., N.I.O.R.D.C. and other affiliate organizations and companies) and has been prepared on the basis of the recognized standards, scientific publications, technical documents, accumulated knowledge and experiences in petroleum industries at national and international levels. Iranian Petroleum Standards are prepared by Iranian Petroleum Standards Organization reviewed and amended by the relevant technical standard committees to incorporate acceptable comments made by oil, gas and petrochemical experts. Standards are finally approved by the “Standards High Council” of Iranian Ministry of Petroleum. Iranian Petroleum Standards (IPS) are subject to amendment withdrawal, if required, thus the latest edition of IPS shall be applicable. Any comment or recommendation submitted to the “Iranian Petroleum Standards Organization” will be evaluated in the relevant technical committee and will be considered in the next revision, upon approval. GENERAL DEFINITIONS: Throughout this Standard the following definitions shall apply. “COMPANY” : Refers to one of the related and/or affiliated companies of the Iranian Ministry of Petroleum such as National Iranian Oil Company, National Iranian Gas Company, National Petrochemical Company etc. “PURCHASER” : Means the “Company “ Where this standard is part of direct purchaser order by the “Company”, and the “Contractor” where this Standard is a part of contract documents. “VENDOR” and “SUPPLIER” : Refers to firm or person who will supply and/or fabricate the equipment or material. “WILL” : Is normally used in connection with the action by the “Company” rather than by a contractor, supplier or vendor. “MAY” : Is used where a provision is completely discretionary. “SH