BM2P0XXseriesPWMFlybackconverterTechnical-Rohm.PDFVIP

PWM type AC/DC converter IC with Built-in 650V MOSFET BM2P0XX series PWM Flyback converter Technical Design This application note describes the design of the PWM flyback converters using ROHM’s AC/DC converter IC BM2Pxxx series devices. It explains the selection of external components and provides PCB layout guidelines. Please note that all performance characteristics have to be verified. They are not guaranteed by the PCB layout shown here. ● Description The BM2Pxxx series of ICs are AC/DC converters for PWM switching, incorporating a built-in starter circuit having withstanding voltage of 650V and a switching MOSFET having withstanding voltage of 650V. With ROHM’s original high-speed switching MOSFET built inside, it is possible to increase the peak current, contributes to miniaturization of the magnetic components. BM2Pxxx supports both isolated and non-isolated circuits, enabling simpler design of various types of low-power converters. ● Key features - PWM frequency 65kHz (with frequency-hopping function)/ Current mode - Burst-operation and frequency reduction functions when load is light - Built-in 650V starter circuit / Built-in 650V switching MOSFET - VCC pin under-voltage protection/Over-voltage protection - SOURCE pin Open/ Short protection, Leading-Edge-Blanking function - Per-cycle over-current limiter function - Over-current limiter AC correction function - Soft-start function ● BM2Pxxx Series line-up MOSFET Max Output Power *1 Function Product Package RDS(ON) (max) IDP(max) 85-265Vac Brownout VCC OVP BM2P051F Latch stop