Grundfos pump解析.pptVIP

CR 泵 的 结 构/ Structure CR120CR150 CR 主要结构 轴封 集装式轴封的更换 LaCR机封 加长联轴器 外筒体密封 旋转组件 叶轮 连接口 基座 CR 泵 的 技 术 参 数（ 续 ）/ Technical Data 1.环境温度/Ambient temp：Max. 40°C 2.最大工作压力，取决于机封形式/ Max operating pressure,it is rest with the type of shaft seal： 3.最小入口压力/Min.Inlet Pressure: 计算NPSHa 4.水泵启/停次数/Frequency of starts and stops： －4KW以下电机，最多启停次数为：Below 4KW 200次/hour －5.5KW及以上电机，最多启停次数为：5.5 KW above 100次/hour 合理的管路设计/Pipework design 截止阀/球阀/valve 过滤器/filter 泵/pump 单向阀/non-return valve 真空压力表/vacuum pressure gauge 压力表/pressure gauge 三通阀/three-way valve 合理的管路设计/Pipework design 合理的管路组成(如上图) /Reasonable pipework design 考虑管路因温度的变化而出水的应力 /Consider pipe’s stress, because changing of the pumped liquid’s temperature 合理的支承/吊挂 /Reasonable supporting/lifting 如有特别要求，考虑系统隔振 /If necessary,isolate the system shake 注意： 泵入口过滤器 /Suction side filter 泵入口管线最好比出口管线大一号 /Suction pipe should bigger than discharge pipe 避免管路窝气 /Avoid air locks 避免虹吸 /Avoid siphon effect 到货验收/Goods Check and Accept 施工前水泵开箱检验、登记 /Checking and register 检查设备包装情况/Checking pump package 拆箱，按照设计图样和订货合同检查产品名称、型号、规格是否一致 Open package,checking the type and specification follow the order 产品外观是否完好/Checking appearance of pump 附件是否齐全/Checking spare parts 如有异常，做好记录并立即书面通知格兰富 Any unconventionality,record and contact Groundfos 启动前准备工作/Prepare for start-up 总体要求 /General 认真阅读产品的“安装和操作说明书”/Installation and operating instructions should be studied carefully before installation 严格按照说明书安装/When installing the pump,the I/O must be follow strictly. 水泵就位 /Pump location 水泵的搬运、起吊和运输要按照产品的要求进行，以防意外 Pump’s carrying,lifting and transport should in accordance with the require. 注意水泵进出水的方向/Notice the direction of flow of liquid. 管路连接 /Connection 在与水泵连接前，管路内部和管端要清理干净/Before connection,pipework should be cleaned. 连接的密封面与螺纹不应损坏/The sealed surface of connection and screw thread should be intact. 管路连接时不允许有应力/Ensure the pump is not