09级可编程序控制器及其应用课程.docVIP

09级电子电工《可编程序控制器及其应用》期末试卷 (2011—2012学年第一学期) 班级 学号 姓名 成绩 ? 一(每空1.5分,共30分) 1可编程序控制器的简称 2?PLC主要有 ? 以及 等部分组成3?MPS是 指令,MRD是 指令,MPP 是指令 4?常数K用来表示 进制常数,常数H用来表示 进制常数 PLC开关量输出有 和 三种输出方式步进开始指令 ,步进返回指令 M8013?M8014分别为 的时钟脉冲特殊辅助继电器(在10ms100ms?1s?1min中选)块指令有那两个 ? 将编程器内编写好的程序写入PLC时,PLC必须处在 模式?(RUN,STOP) 二简化或改正下图所示梯形图(每题5分,共10分) 1 ? ?2? ? ? 三(每题10分,共20分) 1 ? ? ? ? ?2?指令程序如下? 0 LD X000 14 MPS 1 MPS 15 AND X004 2 LDI X001 16 ANI X005 3 AND X002 17 OUT Y003 4 LD X002 18 MPP 5 ANI X003 19 AND X006 6 ORB 20 OUT Y004 7 ANB 21 MPP 8 ANI X003 22 LD X007 9 AND X004 23 OR X002 10 OUT Y001 24 ANB 11 MRD 25 ANI X010 12 AND X001 26 OUT Y005 13 OUT Y002 27 END ? ? ? ? ? 四(40分) 1(10分) ?2?有一个指示灯,控制要求为:按下启动按钮后,亮5S,熄灭5S,重复5次后停止工作,试设计梯形并写出指令语句表(15分) 3?试设计两台电动机的控制电路: M1先启动,才允许M2启动;M2先停止,延时10s后,M1才自动停止,且M2可以单独停止;两台电动机均由短路;绘出PLC梯形图(15分)Acknowledgments The authors would like to thank Johns Hopkins University for the TC-1 cells. This work was supported by a National Health Research Institutes intramural grant (IV-103-PP-22) and grants from the National Science Council, which were awarded to Y.C. Song (NSC 99-2321-B-400-004-MY3) and S.J. Liu (NSC 103-2321-B-400-008). Author Contributions Y.C.S. and S.J.L. designed the studies. Y.C.S. performed the research and analyzed the data. Y.C.S. and S.J.L. wrote the manuscript. Additional Information C57BL/6 mice were immunized subcutaneously (s.c.) once with 1 μ g of peptide mixed with or without 10 μ g of CpG adjuvant. After one week, splenocytes were harvested, and the response of IFN-γ -secreting cells was determined by ELISPOT after 48 h of peptide stimulation. Briefly, 2 × 105 splenocytes were incubated with 1 μ g/ml irrelevant peptide or RAH peptide in an anti-IFN-γ -coated polyvinylidene fluoride (PVDF) plate for 48 h. After incu