齐鲁音乐学院办公楼设计研究报告.docVIP

毕业设计 题 目 学 院 专 业 班 级 学 生 学 号 指导教师 二〇一四年月日本办公楼设计计算书。该楼建筑面积 平方米， 建筑设计、抗震等方面的要求，确定合理的结构形式和结构布置方案，确定框架基础的形式根据要求了钢筋混凝土结构。 设计中选取一榀主框架以及楼面屋面板进行截面设计配筋计算。首先根据框架布局确定各构件尺寸，进行永久荷载、活载及风荷载的。采用分层法进行竖向荷载作用下的结构内力计算，D值法水平荷载进行计算。进行内力组合分析找出最不利的一组内力，进行构件计算。楼板采用弹性理论设计。，还进行了楼梯的设计计算。最后，根据计算结果，按照相应的构造要求，绘制了结构施工图，并写出了相应的设计说明。 本设计，计算中多种计算方法得到体现，D 值法，弯矩分配法，分层法等，使自己掌握了多方面的知识。关键词：框架结构；结构设计；内力计算；荷载；钢筋混凝土ABSTRACT The graduation design is mainly covered the metallurgical design institute office building design, structure design and the construction organization design. Throughout the design process, I have actively consult, and strict enforcement of the office building design standards and regulations. Design of this book is Metallurgical Design Institute of Shandong province office building design calculations. The building has five floors, building area of 4235.8square meters, according to the graduation design task book, architectural design, seismic and other aspects of the request, determining the reasonable structure form and the reasonable layout of the structure, determine the basic framework, forms and requirements, according to the requirements of comprehensive considering the office was selected using the reinforced concrete structure. In the design of the main selected a pin frame and floor and roof plate section design and reinforcement calculation. Should first according to the framework of distribution to determine the size of each component, and then the permanent load, live load and wind load and seismic load calculation. Next, using hierarchical method for vertical loads of the structure calculation, at the same time with the method of D value on the level of load calculation. Finally, the combination of internal force analysis, to identify the most disadvantaged group internal force, thus the calculation of component. Floor