英语作业电火花加工概述.ppt

讲解员： 范壮壮 ;Content;1 The concept of the EDM;2 The principle of the EDM; 11;The workpiece and tool are respectively connected with the two input end of pulse power supply,automatic feed adjustment device to make the tool and the workpiece often maintain a small discharge gap,when the pulse voltage is applied to the two poles,in that case and at the relative minimum of a gap or at the lowest insulation strength which the dielectric is punctured ，then producing spark and discharge, when in the instantaneous high temperature，a small portion of the metal of the tool and the workpiece are removed ，