在PS中如何制渐变网点.doc

在PS中如何制作渐变网点 1、我们首先新建立一个文件，如图。　　2、选择渐变工具在空白工作区中拉出一个渐变，效果如图。　　3、然后执行图像--位图操作。　　4、弹出位图设置框，将其参数设置如图。　　5、将半调网屏的参数设置如图。?? 6、网点效果出来了，还可以给它改改颜色，如图。　　7、执行图象——灰度和图象——RGB操作。　　8、将其放大，用魔棒选取黑色。　　9、选择你喜欢的颜色，并将其填充。　　10、图片同样可以实现这种效果。好的，网点图案基本上完成，你可以试试其他颜色效果 方法:只适用于黑色 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the appearance is clean and not damaged. 7.5.8 cables neat and clean, solid binding, binding process in appearance. 7.5.9 the first cable production firm, crafts beautiful, clear signage does not fade. 7.5.10 fireproof plugging tight, no cracks and pores. 7.6 7.6.1 of the standard electrical wiring quality technology cable a, the multi-core wire bunch ar