退变性腰椎管狭症临床路径.docVIP

退变性腰椎管狭窄症临床路径 （县级医院2012年版） 一、退变性腰椎管狭窄症临床路径标准住院流程 （一）适用对象。 第一诊断为退变性腰椎管狭窄症（ICD10:M48.03）ICD-10：M48.0按照执行抗菌药物选择与使用时机应按照执行愈合好无感染需要住院处理的并发症和合并症二、退变性腰椎管狭窄症临床路径表单 适用对象：第一诊断为退变性腰椎管狭窄症（ICD10：M48.0） 患者姓名： 性别： 年龄： 住院号： 门诊号： 住院日期： 年 月 日 出院日期： 年 月 日 标准住院日 ≤12天 时间 住院第1天 住院第2天 住院第3-5天（术前日） 主 要 诊 疗 工 作 询问病史及体格检查 医师查房 初步的诊断和治疗方案 完成住院志、首次病程、上级医师查房等病历书写 1. 2. □无 □有，原因： 1. 2. □无 □有，原因： 1. 2. 护士 签名 医师 签名 　 　 　 注意神经功能变化 1. 2. □无 □有，原因： 1. 2. □无 □有，原因： 1. 2. 护士 签名 医师 签名 　 　 　  1. 2. □无 □有，原因： 1. 2. □无 □有，原因： 1. 2. 护士 签名 医师 签名 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the appearance is clean and not damaged.