PS制作神秘洞的效果.docVIP

PS制作神秘洞穴 操作过程： 1．新建文档 650×450，并将背景填充成黑色 2．前景色设置为白色，选择画笔工具，新建图层1，绘制一歌柔和的圆点，如附件1；CTRL+T应用自由变换命令，按住shift+alt，以图像中心为基准按指定的纵横比扩大图像，使之充满整张画面，如 3．新建图层2，前景色黑色，背景色白色，应用“滤镜－渲染－云彩”命令， 4．在图层面板中将云雾图层的混合模式设置为线性光，填充值设置为48%。圆形画笔图像受到云雾图像的影响变成不规则形态，Shift+Ctrl+E，将所有图层合并为一个图层。 5．表现颗粒效果：对图像应用“滤镜－象素化－晶格化”命令，形成不规则形状的颗粒 6．合成相近的颜色：对图像应用“滤镜－杂色－中间值”命令，制作按地形的高度排列等高线的阶梯形状 7．图像立体感：Ctrl+J复制被选图层，在图层面板中将副本层隐藏，选择背景层，应用“滤镜－渲染－光照效果”命令，做如下设置，并将纹理通道设置为红色，表现立体效果 8．强调图像的边缘：在图层面板中选择副本层，对图像应用“滤镜－锐化－USM锐化”命令，（数量：479 半径：10）使图像的边界部分明显后，更有立体感 9．在图层面板中，设置图层的混合模式为正片叠底，填充值为75％ 以上的制作可能会让觉得有些单调10．为黑白图像上色：在图层面板中单击“创建新的填充或调整图层”按钮，选择“渐变映射”选项，设置自己喜欢的颜色 也可以尝试其他的色彩 还可以结合其他的效果 ? spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, b