h o w t o s e t u p y o u r t n t3（h o w t o s e t u p y o u r t n t3）.docVIP

THE JMW-12.7 TONEARM SETUP AND INSTRUCTION MANUAL VPI INDUSTRIES INC., 77 CLIFFWOOD AVE #3B, CLIFFWOOD N.J. 07721 PHONE: 732-583-6895, FAX: 732-946-8578 SETTING YOUR JMW 12.7 MEMORIAL TONE ARM You will see a number of things in plastic bags: Allen wrenches Hex nuts, and washers (for cartridge mounting) Arm mounting and alignment tool Shure stylus gauge Take all these items out and set them aside A. CARTRIDGE MOUNTING: Remove the arm tube from the box (taking special care not to strain or damage, the delicate 4-color wire and Lemo connector) and place it right side up on the foam pad. FOR CARTRIDGES WITH THREADED MOUNTING HOLES: Use the screws supplied by the cartridge manufacturer to mount the cartridge. Any other screws may not fit the thread properly and may even damage the threads and cartridge. USE ONE OF THE SUPPLIED WASHERS UNDER THE SCREW HEAD. For all cartridges with pass through mounting holes use the hardware supplied with the arm. Remember to use the washers under the screw heads to prevent damage to the finish on the JMW arm. In this step, the connectors will be attached to the cartridges terminals. Disregard the color of the insulators on the cartridge clips. THE COLOR CODE OF THE WIRES IS AS FOLLOWS: WHITE = left hot RED = right hot GREEN = right ground BLUE = left ground IF YOUR PHONO SECTION INVERTS PHASE, THE HOT BECOMES THE GROUND COLOR The arm tube should be on its side on the foam pad when doing this. Using tweezers or fine tipped pliers, grip the center of the red wires connector (do not grip the wire) and push it onto the cartridges right hot terminal pin. In the same way, connect each of the remaining connectors to its respective cartridge terminal. Do not push the connectors all the way on, as this could damage the cartridge. Always back up the cartridge with your finger when pushing on the clips. At t