heated oxygen sensor conversion kit installation（加热氧传感器转换套件安装）.docVIP

Heated Oxygen Sensor Conversion Kit Installation by Sean Wall A.K.A. Fastbird Included Items: Passenger Side Conversion Harness ( long one) Driver Side Conversion Harness (not so long one) 2 x 30 Amp Fuses for the power leads Items installed on the harnesses: Ring terminal on each ground wire Weatherproof in-line fuse socket and fuse Items/Tools for Install: Wire Cutters/Strippers Paperclip or very small screwdriver Soldering Gun (optional) Lighter Zip Ties Electrical Tape 7/8” wrench for O2 removal and installation Parts that need to be ordered: GM 4 Wire Oxygen Sensors, GM part number– these are currently available at for $42.08 or you can call up Jason Cromer @ Sam Taylor Buick Cadillac in Ft. Walton Beach FL (877-726-8295 ask for parts then for Jason) where you can probably pay the same but DEFINITELY receive them faster. If anything is noticed to be damaged or mission please contact me ASAP at (609) 792-5995 or Fastbird@F. I guarantee my work and will to everything I can to make you happy. So lets get started. If you have this kit in your hands, you obviously know what it’s for. I’ve done my best to make a plug and play kit for you, so the only connection you have to make is the power and ground connections at the fuse block and radiator cross brace. 1. Installation and Routing of Conversion Harness Routing the wires is completely up to you. I’ll do my best to explain how I had mine routed, but each car is going to have it’s own specific needs based on setup The longer of the two conversion harnesses is for the passenger side of the car. Between the length of the harness and the length of the harness that comes with the new O2 sensors there should be plenty of length for Long Tube headers. Tip: To make it easier, install your O2 sensor into the exhaust and connect all connections. This way you can route any extra wiring forward where it’s easier to tie off and hide and less likely to be damaged by heat or mov