grounding- secondary（接地-二）.docVIP

General RELATED SECTIONS Section 01 91 13 – Commissioning (Cx) Requirements. Section 26 05 00 – Common Work Results - Electrical. Grounding conductors for all distribution grounding to be insulated copper, uninsulated where in contact with earth. Copper conductors shall, at a minimum, be used in the following areas: grounding of transformer neutrals, service entrance switch ground of neutral, padmount transformer grounding, ground rider conductors from main ground station to sub-closets, telephone and data system grounds and circuits rated less than 60 amps. Where type ACM conductors are used for circuits rated 60 amps or greater, type ACM bonding conductor is permitted. REFERENCES American National Standards Institute (ANSI)/Institute of Electrical and Electronics Engineers (IEEE) ANSI/IEEE 837, Qualifying Permanent Connections Used in Substation Grounding. Canadian Standards Association, (CSA) CAN/CSA Z32, Electrical Safety and Essential Electrical Systems in Health Care Facilities, where applicable. Products EQUIPMENT Clamps for grounding of conductor: size as indicated to electrically conductive underground water pipe. Copper conductor: minimum 6 m long for each concrete encased electrode, bare, stranded, tinned, soft annealed, size as indicated. Rod electrodes: copper clad steel 19 mm dia by 3 m long. Plate electrodes: copper, surface area 0.2 m2, 1.6 mm thick. Grounding conductors: bare stranded copper, soft annealed, size as indicated. Insulated grounding conductors: green, type TW. Ground bus: copper, size as indicated, complete with insulated supports, fastenings, connectors. Non-corroding accessories necessary for grounding system, type, size, material as indicated, including but not necessarily limited to: Grounding and bonding bushings. Protective type clamps. Bolted type conductor connectors, as required by local authority having jurisdiction.. Thermit welded type conductor connectors, as indicated. Bonding jumpers, straps. Pressure wire connectors. Ex