我n s t l l t i o n -先锋覆盖.docVIP

INSTALLATION OPERATION MAINTENANCE MANUAL FOR MODEL RP4500SARG “RACK ‘N PINION - STRONG ARM” ROLLMASTER w/ GANTRY ATTENTION DISTRIBUTOR: DO NOT DISCARD PLEASE GIVE THIS MANUAL DRAWINGS TO THE CUSTOMER WHEN THE UNIT IS DELIVERED. RP 4500SARG RACK ‘N PINION ROLLMASTER w/ GANTRY INSTALLATION INSTRUCTIONS READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY BEFORE BEGINNING THE INSTALLATION. USE THESE INSTRUCTIONS WITH THE DRAWINGS INCLUDED. UNPACK, IDENTIFY AND FAMILIARIZE YOURSELF WITH THE VARIOUS COMPONENTS OF THE UNIT. REPLACE ALL WARNING LABELS WHEN THEY BECOME UNREADABLE THIS SYSTEM IS DESIGNED TO BE USED WITH CONTAINERS THAT ARE THE SAME LENGTH, BUT HAVE DIFFERENT SIDE HEIGHTS. VARIOUS LENGTH CONTAINERS MAY BE USED WITH THIS SYSTEM AS LONG AS THE REAR OF ALL THE CONTAINERS ENDS UP IN THE SAME PLACE ON  TRUCK. SHORT STOPS OR THE LIKE MAY HAVE TO BE USED IF THIS  SITUATION EXISTS. PRIOR TO INSTALLING THE FLOW DIVERTER AND COVER CONTROL VALVE INTO YOUR TRUCKS HYDRAULIC SYSTEM, WE RECOMMEND THAT YOU CHECK WITH THE HOIST MANUFACTURER FOR POSSIBLE WARRANTY IMPLICATIONS. 1. MOUNTING THE GANTRY AND ROLL REST A. Pick a suitable place on the chassis of the truck directly behind the cab to mount the GANTRY and ROLL BASE/REST ASSEMBLY. Clear away or re-route any hoses, cable, etc. that may interfere with mounting the GANTRY to the chassis. The GANTRY can be mounted to the chassis using the -2- CHASSIS MOUNTING ANGLES provided. These can be bolted to the chassis using grade 8 hardware and then welding the GANTRY on top of these angles or these angles can be welded to existing plates that are already bolted to the chassis. Another method that utilizes brackets, etc. that are already bolted to the chassis, is to weld a piece of channel or tube to existing brackets across th