DimuonForwardSpectrometerMay2008CosmicRun.ppt

Dimuon Forward Spectrometer May 2008 Cosmic Run General Planning muon tracking has to run in a dedicated trigger class with muon trigger and V0 : trigger send by muon trigger test stability test calibration trigger mixed with physics trigger run with pulser (600Hz) from muon triger DAQ/TRIGGER (cluster of detectors triggered by different trigger classes) tests week 15 Planning run with St1, St2 and Ch5 (ventilation and temperature probes is mandatory) include part of St4 or St5 ?! station 9 is the candidate To do list LC2 installation : do not overwrite the files in the $LC2_CONFIG go to a new directory /opt/daq-MCH/ECS/ Trigger dispatching crate : missing kernel (Anton ?) user interface vs smi CROCUS software upgrade Finish the DA/script for calibration… Probably a full revision of the DCS FSM is necessary ; it will imply some work on the ECS side as well. “Long term thinking” to have a safe operating procedure for the muon spectrometer. → St1 : ~45 manus and 1 patch bus to be changed → St2 : few manus to change, fix problem with crocus 2565 (backplane vs software ?) → St345 : check with Herve. To do list temperature probes in St3 pressure sensors in St 2 (the one for St1 is not responding properly, having the value from St2 could help to know if the problem come from the ELMB readout) → Need to finish MUON interlock (if ventilation goes off or gas stop flowing…) → HV trip problem : could it come from the gas purity ? This need to be check urgently !! → Send trigger PS back to Wiener. Ask them to check the problem detected by L.Wallet (bit rate transfer is not save when rack’s tunred off). + this PS sometimes switch off (apparently because of a over/under current) ; we still need to investigate the origin of this. Tuesday 8th April DCS intervention (network, racks powered down) of Monday 7th is still has still some effects... Status of the low voltage power suplies : some problems CH1R and CROCUS R are missing (still in germany) → A