Analysis of the Impact of P-Ratio on BER, Q-Factor and OSNR of Radio over Fiber (RoF) System英文文献资料.docVIP

Optics and Photonics Journal, 2011, 1, 179-188 doi:10.4236/opj.2011.14029 Published Online December 2011 (http://www.SciRP.org/journal/opj) Analysis of the Impact of P-Ratio on BER, Q-Factor and OSNR of Radio over Fiber (RoF) System Vishal Sharma , Amarpal Singh , Ajay K. Sharma 1 2 3 Shaheed Bhagat Singh College of Engineering and Technology, Ferozepur, India Beant College of Engineering and Technology, Gurdaspur, India 1 2 3 Dr. B.R. Ambedkar NIT, Jalandhar, India E-mail: er_vishusharma@ Received September 15, 2011; revised October 15, 2011; accepted November 6, 2011 Abstract The impact of p-ratio i.e. ratio of carrier power to total received RF power at control office (CO) on Bit error rate (BER), Q- performance parameter and Optical signal noise ratio (OSNR) of RoF communication system is theoretically analyzed using angular full-linewidth at half maximum (FWHM) of Lorentzian shape for the RF oscillator in this paper. As reduction in Laser linewidth improves the performance of RoF system, the RF oscillator linewidth at FWHM also plays an important role in improving the performance of RoF system. Keywords: RoF System, OSNR Parameter, BER, Q-Parameter, Fiber Dispersion, Matlab 7.0 1. Introduction carrier. Furthermore, the conventional optical double sideband (ODSB) external modulation scheme degrades the received RF signal power due to fiber chromatic dis- persion drastically. For frequency range beyond 5 GHz external modulation is needed for higher speeds. No doubt such systems are capable of meeting the future requirements of High speed high data transfer services but some degradations effects the performance of such systems such as fiber dispersion and modulator’s non- nearity. For overcoming this power degradation, an opti- cal single sideband (OSSB) external modulation scheme is employed [5]. The effect of pha