轴对称拉深成形法兰变形区临界压边力.pdfVIP

E1111 Available online at www.sciencedirect.∞m _- Transactions of , ，~ .号11 ScienceOirect Nonferrous Metals Society of China El.SEVIER Press Trans. Nonferrous Met. Soc. China 22(2012) s239-s246 Critical blank-holder force in axisymme仕ic deep drawing 1 2 1 1 QIN Si-ji , XIONG Bai-qing , LU Hong , ZHANG Ting-ting 1. Key Laboratory ofAdvanced Forging and Stamping Technology and Science 仙1inis位y ofEducation) , Yanshan University, Qinhuangdao 066004 , China; 2. State Key Laboratory for Fabrication and Process ofNonferrous Metals , Beijing General Research Institute forNonferrous Metals , Beijing 100088, China Received 28 August 2012; accepted 25 October 2012 Abstract: An analytical approach for predicting the critical blank holding force (BHF) was presented. Using energy method, the analysis provides the circumferential stress and the equivalent strain as functions of radius under the plane strain and the equivalent s田in is inversely proportional to the radius respectively. The maximurn relative eηOTS of the circumferential stress and the equivalent strain are 22.3% and 35.9% respectively under the two conditions for some