AZ31镁合金变形行为的热力模拟.pdfVIP

中南大学学报(自然科学版} Vo l.39 NO.2 第39 卷第2 期 2008 年4 月 J. Cent. South Univ. (Science and Technology) Apr.2oo8 AZ31 镶合金变形行为的热/力模拟 余珉，史提，王日初，黎文献，王晓艳，蔡志勇 (中南大学材料科学与工程院，湖南长沙， 410083) l 摘 要=采用 GLEEBLE-15∞热/力模拟机在变形温度为 423-723 K，应变速率为 0.01-10s- ，最大变形量为 60% 的条件下对铸态AZ31 筷合金进行热/力模拟研究，并结合热变形后显微组织，分析合金力学性能与显微组织之间 的关系.研究结果表明2 应变速率和变形温度是影响变形激活能的关键参数:当变形温度一定时，流变应力和应 变速率之间呈线性关系，含金的变形激活能在 523-573 K 时变化不大，而在大于 573 K 时增大较快，可用包含 Arrheniues 项的参数Z描述AZ31 镶合金热压缩变形的流变应力行为。 关键i司: AZ31 续合金:热模拟:流变应力 中图分类号: TGI46 文献标识码:A 文章编号: 1672-7207(2008)02-021命。5 Thermo-mechanical simulation of AZ31 magnesium alloy YU Kun , SHI Ti , WANG Ri-chu , LI Wen-xian, WANG Xiao-yan , CAI Zhi-yong (Sch∞1 of Materials Science and Engineering, Centra1 South University, Changsha 410083 , China) Abstract: Using GLEEBLE-1500 thenno-mechanical simulator, the stress-strain behavior of as-cast AZ31 magnesium alloy at v红ious strain rates 回d dífferent deformation temperatures were investigated with maximum strain of 60%. 咀e relation between microstructure and mechanical prop町ty of the experimental alloy was analyzed in hot-compression procedure. The experimental results show 也at 也.e strain rate and the defonnation temperature are the key parameters of deformation activation ene恕y. When the defonnation tempera阳re is defmite, the relation between flow stress and strain rate is line瓦 and the variation of deformation activation energy of experirnen时 alloy is not big in 523-573 K, but the deformation actívation energy increases rapidly above 573 K. The r冒lation of