磨料与粗糙度的关系(国外英文资料).docVIP

磨料与粗糙度的关系(国外英文资料) Abrasive/surface profile comparison table (abrasive code adopted SAE J4444:1984) 25? M surface profile 37.5? M surface profile 50? M surface profile 62.5? M surface profile 70/100? M surface profile 30/60 of silica sand G - 80 steel grit S - 110 steel shot * 80 mesh garnet 100 mesh alumina sand 20/40 mesh cinder 16/35 of silica sand G - 50 steel grit S - 170 steel shot * 36 mu garnet 50 mesh alumina sand 12/40 mesh cinder 16/35 of silica sand G - 40 steel grit S - 230 steel shot * 36 mu garnet 36 mu alumina sand 12/40 mesh cinder 8/35 of silica sand G - 40 steel grit S - 280 steel shot * 16 orders garnet 24 eyes of alumina sand 10/40 mesh cinder 8/20 of silica sand G - 25 steel grit Steel shot * S - 330 or 330 16 orders garnet 10/40 mesh cinder The specifications of the G80 are: 0.2-0.4 S110:0.3-0.6 The specification of G50 is: 0.3 to 0.6 S170:0.4 to 0.8 The G40 is: 0.6-1.0/0.4-0.8 S230:0.6-1.0 The G25 specifications are: 0.8-1.25 S280, which is 0.8-1.25 The specifications for the S330 are: 0.8-1.25 S390:1.0-1.6 Sand blast to SA2.5 productivity (7 kg pressure, 9.5 mm diameter spray nozzle) abrasive Abrasive consumption productivity opinion 16/40 of silica sand 12.7 KP/sq. M 26 sq. M/hr 35? M surface profile; dust 12/30 broken flint 17.6 KP/sq. M 15 sq. M/hr 75? M surface profile 50/100 fairy stone 15.1 KP/sq. M 27 sq. M/hr 10-15? M surface profile 16/40 mesh cinder 15.1 KP/sq. M 21 sq. M/hr 60-70? M surface profile; dust 16/40 copper slag 15.1 KP/sq. M 24 sq. M/hr 50? M surface profile 36 mu garnet * 17.6 KP/sq. M 20 sq. M/hr 35? M has very little dust on the surface 36 mu alumina * 15.1 KP/sq. M 25 sq. M/hr 35? M has very little dust on the surface G - 40 steel grit 26.8 KP/sq. M 17 sq. M/hr 60-70? M surface profile, no dust * these abrasive materials can be reused. Production efficiency of different sandblasting standard Method Production rate Abrasive, informs Sa3 90 sq. M 5600 kg Sa2.5 140 sq. M 4500 kg Sa2, 230 sq. M 3600 kg Sa1 480 sq. M 3000