HDPE土工膜主要施工方法(国外英文资料).docVIP

HDPE土工膜主要施工方法(国外英文资料) Main construction method of HDPE The requirements before construction 1 landfill anti-seepage construction is the core of the whole project, therefore, the construction must be under the supervision of party a, design, supervision together, under the close cooperation of the civil parties to complete. The materials used in the project must meet the requirements. The ground level of the construction must meet the design requirement. The equipment of material construction must meet the requirements. The builders must be skilled in the work. Third, control the requirement of laying the ground at the ground level: four degrees Level 1: plus or minus 2cm/m2, flat and straight; Compactness: 95 percent, which can be used to lay the earthen film on it. 3 longitudinal and horizontal slope: above 2%, the bottom of the landfills must be conducive to the flow of leachate. Cleanliness: the vertical depth of 2.50 cm is not allowed to have roots, debris, stones, concrete particles, etc. The construction of climate requirements: 1 the temperature of 5 to 40 ℃ advisable, given the geomembrane heat bilges cold shrink, according to experience, when the day is cold, the laying of geomembrane should some; When the weather is hot, relax; But be careful to avoid the heat in the middle of the summer. Wind and rain: wind above 4 or rainy days should be stopped. In the wind hour, it is appropriate to use the sandbag to hold down the earthen membrane. 5, HDPE mural construction installation 1 HDPE film construction installation process flowchart Cutting and shipping: According to the record of the laying of the base, the large sheaf of the earthen film, the number record, is carried to the laying site by number. Note that the earthwork film should not be dragged and dragged in the course of transportation. 3 HDPE mural installation installation 1) it should be extended from the bottom to the top, not too tight, and should be left over 1.50% of the rest, in case of parti