酚醛树脂浸渍压缩密实化杉木燃烧特性.pdfVIP

浙江农林大学学报， 2015 , 32(3): 399 - 403 }ourn a1 01 Zhejiang A F University doi: 10.11833/j.issn.2095-0756.2015.03.0 1O 酣醒树脂浸渍压缩密实化杉木燃烧特性 章卫钢，鲍滨福，杜春贵，张 宏 (浙江农林大学工程学院木材科学与技术重点实验室，浙江临安 311300) 摘要:采用锥形量热仪对盼路树脂浸;责压缩密实化杉木 Cunninghαmia lωlCeolωα 的燃烧性能进行测定，分析密实化 杉木燃烧剩余物特征、热释放速率、释热总量、释烟速率、释烟总量、一氧化碳释放量、有效燃烧热、质量损失 率等燃烧特性与这生杉木素材的变化。结采表明:杉木密实处理后，燃烧剩余物增多，并具有一定强度;密实化 2 杉木释热总量高于素材，达到 160.98 kWm- ，而 205 后迅速降低，再无热释放峰，而素材在 400 5 时仍出现热释 放峰;其锋热速率、有效燃烧热和质量损失率均低于素材;释烟曲线中素材第二发烟峰在 3005 出现，持续时间近 100 5 ，而密实化杉木该峰推后了近 6 min ，绎烟速率也减缓并降低;密实化杉木平均一氧化碳产率(y，) 高峰向后推 迟近 705 ，持续奉手放时间也由素材的 605 降低到 355 ，而后迅速降低。因 9 参 11 关键词:木材科学与技术;浸渍压缩;密实化;锥形量热仪;阻燃木材;杉木 中图分类号: S78 1.7 文献标志码:A 文章编号: 2096-0756(2015)03-0399-05 Combustion properties of Chinese fir densified by phenolic resin impregnation and compression ZHANG Weigang , BAO Binfu , DU Chungui , ZHANG Hong (Laboratory of Wood Science and Technology, School of Engineering, Zhejiang A F University , Lin an 311300, Zhejiang, China) Abstract: For efficient utilizing of fast-growing Chine5e fir , make it to densified Chinese fir (Cunninghamia lanceolata) which immersion by phenolic resin and followed by compression. Using a cone calorimeter to test the combustion characteristics of densified Chinese fir, studying on combustion performance like heat release rate , total heat release , smoke production rate , total smoke rate , CO yield , effective heat of combustion, and mass loss rate with EN 1505660-1. Results showed that densified Chinese fir aft巳r increasing density , the total heat released reached 160.98 k W . m气 and afterward this peak decreased quickly with no peak heat release af- ter 20 s. But non-densified