金属筒形件强力反旋变形过程的数值模拟分析.pdfVIP

上半月出版 Casting. For:伊IgWelding冒金属锦锻焊技术 金属筒形件强力反旋变形过程的数值模拟分析 牵露露，在t茂华，白玉l晦 (昆明级工大学机电工程学院，云南昆明 650093) 摘 要;为了确定更为符合实际的简形件强力旋应工艺参数的选用原则，利用有限元软件 Abaqus/Explicit 准静态 模块，对一次减薄成形的工艺.不间工艺参数下简形件两旋轮反旋旋压过程进行了动态模拟、变形以及应力应变的分 析。分析袋明:强力旋压毛极件的变形流动主要是轴向变形，影响成形质量的因素主要是成形过程中的径向变形和切向 0 变形。当旋轮回角半径r-=15Jlllll ，旋轮工作角 α:::30 时，金属旋压件的径向变形和切向变形比较合理，既容易顺利激行旋 压成形又不易引起失稳现象，为实际加工旋轮的参数选择提供了依据。 关键词:强力旋压;筒形件:数值模拟 中图分类号 文献标识码:A 文章编号:1001翩3814(2010归队0115-05 :TG376 Numerical Simulation Analysis of Backward Spinning Process for Metallic Cylinders LI Lulu , DU Maohua , BAI Yufeng (Fac崎:yolMechm山al and Electrical E哺inee吨; Kunmi咆UniversiJy 01灿即e and Tech旧时 Kunming 65∞93， Chi，叫 Abs衍act: In order ωobtain actual pre如red principle of processing parame句t about roller backward spi.nning for cylinders, 3D dynamic simul础。n， deformation，确切s and s阳in analysis 阳 two阳roller .backward spinning of cylinder m伽r different processing parame阳s were carried on using FEA so食ware AbaqusIExplicit The results indicate that the deformation f10w of power spinning is mainly axial defonnation, the radial deform剧。rn and circumferential deformation have an impact on the fonning quality. When the fillet radius of spinni吨roller is 15 mm and rol1町 fonning ang1e is 300 , 也e radial deformation and circumferential deformation of the metallic spinning part is more reasonable ,so it is easy 10 spin and difficultωinduce the phenomenon of instability. These provide 也e basis for p缸田ne伽百 selection of roller in the acωal processing. Key words: power spinning; cylinder; numerical simulation