RTM工艺树脂注射温度优化.pdfVIP

复合材料营报 第 24 卷第3 期 6 月 2007 年 sdc他 JialR/JI-Ù1R/ S也附中山龙(1R/ :ffhlJi妃，伪 Vo l. 24 No. 3 June 2007 文章编号: 1000-385 1( 2007)03-0105四川 RTM 工艺树脂注射温度优化 挑稿牢，段歇斯\带研 (北京航会航天大学材料科学与工辛辛学院，北京 100083 ) 摘 要: 在民丁M 工艺模拟及民丁M 工艺专用树脂蒙古皮特性研究的基础上，提出充模时间与安全系数的乘积小子 树脂低蒙古度平台时间的树脂iì射淑度优化标准和克楼时间、树脂低蒙古度平台时间的计算方法，制定了程序化流程 并编制了软件，使优化得以实施。在此基础上，选取 QY8911-N双马树脂对所选制件进行模拟充模作为注射温度 优化的实例，确定了树脂低蒙古度平台时间的变化范圈，得到了不同条件下的优化注射温度。优化实例表明，优化 软件可实现对树脂泼射源度的优化。 关键词: RTM; 充模时间;低数度平台时间;树脂注射温度;优化 中图分类号: 1B332; 1、B12 文献栋识码:A Optimization of resin injection temperature for RTM process YAO Fujun , DUAN Yuexin费， ZHAO Yan CSchool of Materials Science and En日ineering ， Beijing University of Aeronautics and Astronautics , Beijin日 100083 , China) Abstract: The optimization of RTM processing parameters was studied. The optimization criterion of resin injec- tion temperature , the way of calculating the filling time (tfm) and the time of the low viscosity platform of resin (tpl) were put forward , based on the simulation of the RTM process and the research on the properties of the resin viscosity. A flow chart was made and the software was programmed , 50 that the optimization could be actualized. Furthermore , QY8911- NBMI resin was se!ected as an example of the optimizatîon. 丁he range of tp]ot and the opti- mized injection temperatures under different conditions werc obtained. Thc example indicatωthat the software can achieve the optimization of resin injection temperature. Keywords: RTM; filling time; low viscosity p!atform time; resin injection temperature; optimization 树脂传递模塑(民丁M) 作为复合材料的新一代 尽管现有的 R丁M 工艺模拟仿真系统模拟