焊接安全试题笔试(国外英文资料).docVIP

焊接安全试题笔试(国外英文资料) 1, the question (please fill in the brackets, correct for A, incorrect B). () 1. The welding accident refers to the various kinds of injuries that the worker is engaged in in the welding operation. () 2. Q235A is just a common advanced high quality carbon structural steel, with a carbon content of.0235%. () 3. The welding current is too small, the arc is too short, and easy to bite. () 4.tungsten electrode argon arc welding is a kind of welding method in gas protection welding. () 5. An electric shock is an injury caused by an electric current to the human body. The safety voltage in our country is below 50V. () 7. When the electric shock is first aid, the chest is squeezed. () 8. It is raining weather, and it is possible to conduct outdoor welding operation under special care. () 9. () 10. The wider the explosive limit of flammable gas, the less dangerous the explosion. () 11. The burning conditions are: combustible matter, combustion and fire, all three are necessary. () 12. When the welder is on fire, no foam fire extinguisher should be used before the power supply is cut off. () 13. In the forbidden fire area, the three levels of audit system shall be implemented in different conditions. () 14. Prolonged dissonance can lead to disorders of the central nervous system and vascular system. () 15. The patient should be allowed to lie on his side or lie on his back. () 16. Uv rays can stimulate and injure the eyes and skin strongly. () 17. After cleaning the replacement, no further test will be required after the inspection is passed after the operation is done. () 18. When using a ladder operation, allow two persons to operate on the same ladder at the same time. () 19. The plasma arc welding and cutting are used in high frequency arc, no harm to the human body. () 20. The site of the welding explosion should be set in the area far from the building. () 21. The acetylene cylinder should not be subjected to a violent collision. It will roll over the