螺纹 紧固件生产中应用的相关计算公式(国外英文资料).docVIP

螺纹 紧固件生产中应用的相关计算公式(国外英文资料) Relevant calculation formulas for application in fastener production A, 60 ° the external thread pitch diameter calculation of tooth type and tolerance (GB) 197/196 A: the basic size of the diameter of the thread = the diameter of the thread The formula says d/d minus P times 0.6495 Example: the calculation of the diameter of the M8 thread 8-1.25 * 0.6495 = 8-0.8119 is approximately 7.188 B. The diameter tolerance of the usual 6h external thread (based on the pitch of the pitch) The upper limit is zero. The lower limit is P0.8-0.095 P1.00-0.112 P1.25-0.118 P1.5-0.132 P1.75-0.150 P2.0-0.16 P2.5-0.17 The upper limit formula is the basic size, and the next formula is d2 - hes-td2, which is the basic size of the middle diameter - the deviation - tolerance M8s 6h level tolerance value: 7.188 below: 7.188-0.118 = 7.07 The basic deviation of the diameter of the diameter of the type 6g is the basic deviation of the diameter of the diameter. P 0.80-0.024 P 1.00-0.026 P1.25-0.028 p1.50.032 P1.75-0.034 p2-0.038 p2.5-0.042 The upper limit calculating formula d2 - ges is the basic size - deviation The lower limit calculation formula d2 - dd2 is the basic size - the deviation - tolerance Example M8 of 6g size tolerances: The upper limit is 7.188-0.028 = 7.16 Lower limit: 7.188-0.028-0.118 = 7.042 Note: (1) above the thread tolerance is subject to a coarse thread thread tolerance some corresponding changes of fine thread, but only tolerance, so according to this control not outside the specification limits, therefore, not one by one in the mark. (2) the thread of the polished rod billet diameter size in actual production, according to the design requirements of precision and screw thread processing equipment of the extrusion pressure and corresponding than design thread pitch diameter size increase between 0.04 0.08, and for the thread polished rod billet diameter values, cases of our company outside of the M8 thread level 6 g of polished rod billet diam