vt300简单操作手册（国外英文资料）.doc

vt300简单操作手册（国外英文资料） Electric training The way the system works There are mainly manual (JOG), back reference (REF), semi-automatic (MDI), EDIT (EDIT), AUTO. Manual - instructs the operation of each axis, pins and pins, etc. Check back to the various shafts for reference points Semi-automatic - can execute individual program segments or other functions such as hand shock. Edit-can fix, insert, delete, transport Automatic - execute program stamping artifacts. Boot in. Close the total power supply, make the machine tool bus have electricity. (2).press the POWER ON ON the operating panel, and wait for a 30-second display to show the following alarm: 1000 reference points are not returned, (3).press the pump motor to start the button, start the motor, and show the light. (4) select the JOG (manual) method. (5) press the manual axis movement button - X, -y, which causes X, and the Y axis to leave the origin at more than 200MM. (6). Choose the method of REF. (7).press the manual axis movement button + X, + Y, + T, to make X, Y, and t-axis back to reference point, indicating the light is on, and the back is finished. (8).press the manual axis movement button + C, make the C axis back to reference point, indicate the light is bright, and return to complete. (9). Step on the pedal switch with your foot, and close the clamp. (10).under the REF, press the clamp test key and check the clamp. Note: back and you just need to press the direction key, the machine tool can be carried straight back into action, in front of the shaft to the reference point, not according to the RESET (RESET) to stop. Machine tool testing clamp, X must be on the coordinates of reference points, and not according to the RESET halfway to the test (RESET) to stop, every time machine boot up all need testing clamp. After every move also to test for a clamp, and also need to test clamp after an emergency stop. Remember!!!!!! The construction of a program and the order of execution of a program. A complete pr