“电脑黑屏”故障的软硬件解决大法（国外英文资料）.doc

“电脑黑屏”故障的软硬件解决大法（国外英文资料） The hardware and software solution of computer black screen failure For older or assembled computers, the black screen is a relatively easy failure. There are various hardware reasons for the black screen in the computer, such as the damage of the monitor, the damage of the graphics card, the bad contact of the graphics card, etc. To eliminate black screen problems, should be ruled out, replace the method of combining the basic principle is one of the largest computer parts to replace the first suspected, can according to the following steps to analysis the cause of the problem. Hardware article Check the computer parts for safety First of all, please check whether the display cable is firmly reliably inserted into the host interface, and then check the graphics card and motherboard of contact between the I/O slots are in good condition. If necessary, please remove the graphics card, reinstall it again, make sure it is in place and contact well. Make sure the monitor is damaged If the display and graphics card are secure, then switch to a normal monitor and try it. If its no longer black, the reason is that the monitor can be damaged. Make sure the fan has a problem If the monitor is not damaged, check further if the CPU fan is running. If running, use a multimeter to measure whether the voltage output is normal to plus or minus 12V, plus or minus 15V, if not normally, a power supply should be tried. Monitor CPU, graphics card and memory stick If there is still a black screen, you can remove all the components except the CPU, the graphics card, and the memory bar, and then the computer will be turned on. If memory fails, there should be alarm. If not for memory, switch to a normal CPU and start retesting. If there is still a black screen, you can only change one motherboard, and the problem should be on the motherboard. In addition to the hardware reasons, there are three soft reasons for the black screen. Software article One, the hardware