行波反射法在变压器绕组匝间短路故障定位中的应用.pdfVIP

第44 卷第21 期 Vo 1.44 NO.21 ~~革统保护易拉4时 2016 年 11 月 1 日 Power System Protection and Control Nov. 1, 2016 001: 1O.76671PSPC151917 行波反射法在变压器绕组匣间短路故障定位中的应用 李卓昕1 ，彭敏放l ，黄清秀 1 ，万勋1 ， 2 ，刘达1 (1.湖南大学电气与信息工程学院，湖南长沙 410082; 2. 国网湖南省电力公司电力科学研究院，湖南长沙410007) 摘要:针对变压器绕组轻微臣间短路难以检测的问题，提出利用行波反射波的电压幅值进行臣间短路故障定位的 方法。通过在变压器绕组线端输入单个低压脉冲以获取行波反射信号，从来集到的行波反射信号中提取相应的波 峰电压幅值，以此作为故障诊断的电气量。根据臣间短路后对应臣波阻抗改变引起的反射电压突变，来实现匣间 短路故障定位。仿真结果表明所提方法简单可行。 关键词z 变压器:行波反射法:波阻抗:匣间短路;故障定位 Application ofthe traveling-wave reßection method in inter-turn short fault location for transformer 1 1 1 1 LI Zhuoxinl, PENG Minfang , HUANG Qingxiu , WAN Xun ,2 ,LIU Da (1. College ofElectrical and Information Engineering , Hunan University, Changsha 410082 , China; 2. State Grid Hunan Electric Power Corporation Research Institute, Changsha 410007 , China) Abstrací: Aiming at the problem that the transformer winding is difficult to detect the fault of the inter-turn short circuit, the method of using the voltage 缸nplitude ofthe traveling wave reflected wave to locate the fault location is proposed. It inputs a low voltage pulse into winding wire end to obtain the traveling wave reflection signal and extracts 也e traveling wave reflected signal 仕om the peak voltage amplitude , which is used as the electric quantity of the fault diagnosis. According to the change ofthe reflected voltage caused by the turn to turn short circuit, the fault location ofthe inter-turn short circuit fault is realized. The simulation result shows that the proposed method is simple and feasible. This work is supported by National Natural Science Foundation