《机械设计》考试试题有答案(国外英文资料).docVIP

《机械设计》考试试题有答案(国外英文资料) Doc documents may have a poor browsing experience at the WAP end. It is recommended that you choose TXT, or download the source file to the native view. A mechanical design A test, fill in the blanks (1 point per empty, A total of 20 points) fill in the blanks (1) on the fatigue curve, by A circular base N0 is divided into two areas: when N acuity N0, for (area; when N N0, for ().). The ability of components the elastic modulus of the material) Stiffness means that mechanical parts resist (small, stiffness) under load. The better the sex, the greater the ability to produce the boundary membrane. ( The greater the), The friction of internal friction increases. 4. To improve the performance of lubricating oil in some ways, add a variety of unique performance in lubricating oil chemical composition Is (5. It is because of (type of () and ().) phenomenon, make the belt drive transmission ratio is not accurate. With the main failure form of transmission). ) large, so it causes the transmission The main drawback of worm gear is the lower and higher temperature of the tooth surface. When the chain drive level is arranged, it is best (8. In design, according to the speed of the connecting shaft). ) the next. Select the type of the coupling. ); And () and The ratio of the radius of the radial sliding bearing to the radius of the shaft is known as the eccentricity. 10. For ordinary flat key, considering the load distribution inhomogeneity, the strength of the double bond connection according to ((second from right row, true or false. (each item 1, a total of 10) correct strokes tick wrong strokes x true or false ((the correct stroke tick wrong strokes x,) ) a key gauge All of the components in the cross slider are rigid, so they are rigid coupling. ()))) The smaller the roughness in the surface of the friction surface, the easier it is to achieve the hydrodynamic lubrication. (3) when calculating the strength of shaft, the more accurate than equivalent