物料海上运输培训.ppt

Attendee Requirement: COPC Service Supervisor, Warehouse Man, Material Man; COPC Crane Operator, Rigger, Signalman; COPC Drilling Supervisor; COSL Sr. Toolpusher, HSE, Material Man; Others who may involve in material back loading. Verification Requirement: The sign-on sheets of both hitches shall be approved by facility OIMs and the scan saved at facility S drive. Background Background_ Near Miss of overloading basket On Aug.5, offloading of Shengfeng #2 was stopped when harbor personnel suspected the basket was overweight. (12t gross) Personnel suspected there Were too many 4-1/2” tubing in the basket and unloaded it, one bundle at a time. (Same way it was back loaded to the SF #2 offshore) Calculated total weight was 24.8t gross. Logistics immediately reported condition to offshore for investigation. Cause Analysis: Poor planning and communication. Poor hazard awareness. Did not follow manifesting procedure. Corrective Action: Share near miss in whole field through September 8th, 2013. SWL of basket must be confirmed by lifting crew when back loading pieces. Facility materials man must calculate and record total weight of basket when back loading pieces to insure no over weight condition exists. Background_ Near Miss of overloading basket Aug 16_NM_WHPE_Drilling:Around 12:00PM, 3 bundles of tubing (60 joints) was back-loaded into the long basket on Guoshun-18, a reluctant acceptance by the vessel happened at last. Current Requirements: Background_ Non-compliance of backload cargo from offshore Jutal cage to Hua Teng from WHPA on Aug.28,2013 The wire sling is too short for rigging to crane. Requirements of COPC HSE MS Procedure Material Handling COPC HSE MS Procedure Material Handling 4.5 Offshore Material Handling Back Loading 4.5.1 Line supervision Ensure that the following requirements are performed before any material is back-loaded for transportation back to shore or to other facilities: Ensure all lifting equipment is in good c