RA8000断电重启后CACHE失效和分区表丢失的处理过程.pdfVIP

因需要更换UPS ，机房内所有主机和存储均被关闭，一台ES40 与一台GS160 使用SCSI 线连接RA8000 做TruCluster 集群，关闭RA8000 存储是操作步骤不规范(未shutdown 控制 器，直接断电)导致加点后启动告警，主机端无法识别RA8000 上的LUN ，登录RA8000 查 看发现如下告警 HSZ80_TOPshow this Controller: HSZ80 ZSoftware V83Z-1, Hardware E06 NODE_ID = 5000-1FE1-000C-2020 ALLOCATION_CLASS = 0 SCSI_VERSION = SCSI-2 Configured for dual-redundancy with Z In dual-redundant configuration Device Port SCSI address 7 Time: NOT SET Host PORT_1: SCSI target(s) (0, 1, 2, 3) Preferred target(s) (0, 1) TRANSFER_RATE_REQUESTED = 20MHZ Host Functionality Mode = A Command Console LUN is target 0, lun 3 Host PORT_2: No SCSI targets No preferred targets TRANSFER_RATE_REQUESTED = 20MHZ Cache: 128 megabyte write cache, version 0022 Cache is INVALID. Cache containing unflushed data has been removed from this controller Unknown unflushed data in cache CACHE_FLUSH_TIMER = 60 (seconds) Mirrored Cache: 128 megabyte write cache, version 0022 Cache is INVALID. Cache containing unflushed data has been removed from this controller No unflushed data in cache Battery: MORE THAN 50% CHARGED Expires: 02-APR-2010 NOCACHE_UPS Previous controller operation terminated by power failure. This controller has an invalid cache module Invalid cache -- CLI command set reduced. Type SHOW THIS_CONTROLLER. Please- see user guide to determine corrective action 查询相关资料得知，出现这种现象最常见的原因是关电时没有做Shutdown 操作，当维 持Cache 数据的电池将电耗尽后，无论Cache 有无数据，再次加电时，Controller 就认为丢 失数据，将 CACHE 状态置成 INVALID_CACHE 。其次就是更换Controller 或 Cache，使 Cache 变成Invalid_cache 状态。 可以通过以下命令清除unflushed dat