FRP混凝土用ANSYS模拟的命令流文件（国外英文资料）.docVIP

FRP混凝土用ANSYS模拟的命令流文件 Combin39 unit brief (this paper originates from the Qing River) is very useful, turn slowly learned (2011-07-25 10:01:48) reprint labels: ansyscombine39 classification: professional learning unit. These two days help a student solve the problem in the paper, which involves the connection of different parts of the composite structure. Originally, what she wanted to do was the dynamic process of the separation between the two. To do this, like to use LS-DYNA, which I know very difficult, and time is very limited, this is my first rule. As for the contact analysis, after reference to some information, even if using point to point contact to simulate, it will also cause waste of computer resources. Moreover, this analysis has been carried out by MTS experiments, showing that the connection is tight, and even direct coupling is not far off. After careful consideration and discussion, he gave up the idea of doing contact analysis. Inspired by Lu Xinzhengs article with a citation of up to 230, the analytical scheme was finally established: the Combin39 spring element was used to simulate the relative bond slip between the composite structures. In fact, the slip between steel and concrete is simulated by combin39, has been a mature choice, but I was not very clear that a little embarrassed...... See there are many online and I like the combin novice, asking some low-level issues (it is because of them, so I only need Google ~ OK), I have recently learned some knowledge summarized as follows, welcomed the discussion or criticism. 1.Combin39 is a node that contains two of the one-dimensional nonlinear properties of unidirectional force unit in 1-D, 2-D, or 3-D application with longitudinal and torsional capacity, each node unit has X, Y, Z, three degrees of freedom. 2., this unit has the ability to deform large, when you need to open the NLGEOM option and make KEYOPT (4) = 1 or 3. 3.combin39 requires a load displacement curve (F - D) to define the nature