操作水泥窑的若干体会（国外英文资料）.docVIP

操作水泥窑的若干体会 Some experience of Gao Yuping reproduced the label operation of cement kiln gradually: Cement Technology Control of fuel ratio for kiln and calciner Kiln / decomposition furnace fuel ratio control should be based on the following principles: (1) the kiln and the gas temperature of decomposing furnace should not be higher than the normal value; (2) ventilation in reasonable circumstances, the oxygen content of the kiln and calciner outlet in the exhaust gas should be kept in a proper range, should as far as possible to avoid the emergence of carbon monoxide; (3) the temperature and ventilation could improve the fuel ratio of decomposing furnace. These principles are easy to understand and most of them can be carried out, but there are many people who still have some vague ideas and can not deal with them well when confronted with problems. The fuzzy understanding of the kiln to decomposition temperature, furnace area between the crust that is serious due to the decomposition furnace fuel caused by operation, thus always reduce decomposition furnace fuel, and then increase the kiln fuel, the results of this regional temperature increased further, the crust is more serious, kiln condition worsened. In fact, in addition to kiln gas and furnace gas separated from the double series kiln, it is mainly due to excessive fuel in the kiln. As we all know, the decomposition furnace is an efficient heat exchanger, the decomposition furnace more fuel, the exhaust gas temperature is not too high and the furnace material can obtain a higher decomposition rate. But if this part should be added to the furnace, the decomposition rate of the kiln material will be low, which will increase the burden on the kiln. Because the kiln heat exchange efficiency is low, in order to ensure the normal burning clinker, it should be added to the fuel in the kiln, but by the combustion space and the heat exchange efficiency limit, to the decomposition temperature of the furnace kiln area b