胶印管理（Offset printing management）.docVIP

胶印管理（Offset printing management） Standardization of offset printing I. environmental conditions: 1, room temperature: temperature throughout the year in 30 ℃, 20 ℃ - day within 3 ℃ temperature change. Monitor every 2 hours (responsible person, record, check, archive) 2. Humidity: the annual humidity change is between 45% and 65%. Change no more than 10% a day. Monitor every 2 hours. 3. Cleaning: daily cleaning work environment, such as using spray powder to pay special attention to the cleaning around the spraying machine, machine table sanitation. Finished products, semi-finished products, materials (paper, auxiliaries), school paper, non-conforming products and waste products are strictly placed according to the height of the region. 4. Dustproof: the doors and Windows are tightly closed and the paper wool paper is cleaned every day. Dust off the ink before adding ink. 5, lighting: light source is adequate, workshop, the machine reach above (20 w - 25 w / ㎡). See the sample station to use standard light source. (color temperature: 6500K, power: 58W). 6. Water for the distribution of water: purity, impurity and conductivity of 800-1400 after filtration. The conductivity is less affected by the alcohol value, the influence of the water bucket is larger, and the conductivity decrease should add water bucket fluid. Ii. Requirements for raw materials: 1. Ink: use the company test to determine the normal qualified ink brand. 2. Paper: wrap and wrap the paper after cutting to prevent deformation. When cutting paper, every 5,000 pieces of paper will be inspected once every 5, 000 pieces of paper, namely, the paper is not more than 0.5mm apart from the standard. (for gold and silver, laser and other types of paper, the time should not exceed 48 hours) 3. Printing plate: the assistant shall receive the printing plate from the work order to the plate, and confirm the seal certificate of the printing plate. The pilot will check whether there are scratches and dirty marks on t