hp5000问题解答（Hp5000 questions answered）.docVIP

hp5000问题解答（Hp5000 questions answered） 1. questions: HP DesignJet5000 on paper and paper cutting is sometimes particularly waste, how to operate, you can save paper? Answer: first of all, in the paper before the inspection panel in TUR installed (plotter paper receiver) in the TUR installed =YES option, because the choice of yes, meant using paper receiver, at this point, the paper in front of whether or not neat plotter will think you enabled the paper receiver need paper in front of to stick to the toilet roll paper receiver on so called on the paper cutting paper is canceled. In addition, after the paper is good, the plotter is in the Ready state, then the TUR installed (receiver) option is set to TUR installed =NO state, that is, to close the paper collector. Set the cutter cutter (cutter) option to cutter=on, i.e. turn on the cutter. At this point, the plotter is in the automatic cutting state, so that the automatic paper cut paper feedcut (Form) to save paper. 2. questions: when HP DesignJet5000 output, the blank space on both sides of the paper is obviously over 7mm. How can I solve this problem? Answer: first check the Mongolia and Thailand software in the paper set about margin is zero, if zero output still margin greatly, and then check the plotter panel menu under margins page format (margin) option is margins=normal (normal) state. 3. questions: HP DesignJet5000 output is always mirrored output, the output settings are not set before the mirror, why? Answer: if the output does not actually mirror in both Photoshop and mirroring=off, check the mirroring (mirror) option under the page format menu in the plotter panel to see if it is in the off state. 4. questions: HP DesignJet5000 in the picture after printing completely continue to move forward, paper, how to solve? Answer: first check automatically set the paper in the set with Mongolia and Thailand software output before the printer is clicked, if Mongolia and Thailand in the paper set no problem, then c