itip网管（Itip network）.docVIP

itip网管（Itip network） The threshold should be set on the server, and the server will be responsible for the alarm and display after receiving the data The client is only responsible for collecting and sending data to the server. Furthermore, you can receive commands from the server ************************************** Send the SNMP message to the 161 port of the router in this path, Make sure that it runs the SNMP protocol and gets the routing table through the SNMP GetR operation There are very important MIB variables, ipRouteType, ipRouteDest, and ipRouteMask, They represent the routing type and the destination, the network address, and the destination network Mask if the ipRouteType is 3, which means that the destination network is directly connected to the router Here we find the item ipRouteType 3, and ipRouteType and ipRouteDest Operations are performed to obtain the subnet IP range directly connected to the router ******************************************* Network management system (NMS): fault management, performance management, configuration management, security management, billing management. Functions: network topology automatic discovery, network fault reporting and processing, performance data acquisition and visual analysis; Billing data acquisition and basic security management tools ******************************************** Lets start with the sysSerives value of the system group, which indicates the value of the initial value of the service provided by the entity. The value of the SysServices object is interpreted by 7 bit encoding. A layer corresponding to each of the TCP/IP or OSI structures. The lowest bit corresponds to one layer, and if the system provides service at a particular level, the corresponding bits are set: SyServices = Sigma 2^ (L-1) L represents the number of layers, such as a node that hosts the application service, then the binary value is 1001000, or the decimal value is 72, and 72 = (2^ (4-1) +2^ (7-1)), which indicates th